Deceleration DC motor and supporting wheel, smart car chassis, motor / robot car wheels for arduino or similar.

These motors have an operating voltage of 3-12 volts and are reversible.

They measure approximately 70 mm x 25 mm.

The wheel is approximately 65/70 mm in diameter, and extends below the lowest point of motor approximately 16 mm.

They can be mounted in ether vertical or horizontal positions.  

They have a removable axle on ether side.

 Total weight: 67g

 Operating voltage: 3V ~ 12V DC (recommended value is 6 ~ 8V)

 Maximum torque: 800g.cm (3V)

 Speed without load: 170RMP (3V)

 Reduction ratio: 1:48

 Load current: 70mA (250mA MAX) (3V pm)

 With EMC, it has strong anti-interference ability and causes no interference to micro-controller.

Comes with 2 mounting screws